![change motherboard on hpe 510t change motherboard on hpe 510t](https://i.ebayimg.com/images/g/UR4AAOSwGBhaaKGQ/s-l300.jpg)
6 Press the front panel into the computer. Swing the right side of the panel toward the computer. 1 2 1 Insert the drive partway into the computer bay.ĥ Hold the front panel over the computer, and then press the left side of the panel, inserting the tabs into the computer. Hewlett-Packard always provides quality parts that meet or exceed your original computer specifications. IMPORTANT: The new (replacement) part may not look the same as the original part, due to different manufacturers or models. Replacing a CD or DVD Drive 3 Pull out the drive latch (1), swing it to the right (2), and release it into the hole labeled 2 on the computer. Plugs without a latch: For plugs without a latch, pull the plug straight out from the connector. In addition, some plugs have a latch that must be pressed or squeezed to release the plug while pulling it from the connector. 14 Pull the drive completely out through the front of the computer. 12 Push the drive partway out through the front of the computer.ĭisconnect the cables from the drive: The plugs on the cables are keyed and can be inserted only when aligned properly with the connector on the drive. 1 2 10 Locate the CD/DVD drive you want to replace (and also the drive latch for it). 11 Pull out the drive latch (1), and then swing it to the left until it is in the center position (2). Pull each of the tabs out slightly, away from the computer, to release the panel.ĩ Swing the front panel open toward the left, and then lift it off the computer. 8 Locate the three tabs that secure the front panel to the computer. 6 Grasp the handle, and pull the side panel about 2.5 cm (1 inch) toward the back of the computer to release it. 7 Tilt out the top of the side panel, and then lift the panel from the computer. Flathead screwdriver 3 Turn off the computer.ĥ Loosen the side panel thumbscrew on the back of the computer. Tools Needed 2 Remove the Pocket Media Drive, if it is present. 1 Before you begin servicing the computer, press the Eject button, and remove any CD or DVD from the drive tray. Removing and Replacing a CD or DVD Drive 15–25 minutes Before You Begin Removing a CD or DVD Drive Observe the following requirements before removing and replacing a CD or DVD optical disc drive.
![change motherboard on hpe 510t change motherboard on hpe 510t](https://www.parkytowers.me.uk/thin/hp/t510/imgs/t510_pci_sata.jpg)
5 Slide the side panel toward the front of the computer into place.Ħ 584883-001 - Removing and Replacing the Front Panel 7 Reconnect all peripherals and cables, and then turn on the computer. 6 Tighten the side panel thumbscrew on the back of the computer. Swing the top of the panel toward the computer, inserting the top tabs into the rail slots. Replacing the Front Panel IMPORTANT: The new (replacement) part may not look the same as the original part, due to different manufacturers or models.Ĥ Place the bottom of the panel on the computer, inserting the tabs on the inside of the panel into the rail slots on the computer. 3 Hold the side panel over the side of the computer with the front edge of the panel about 2.5 cm (1 inch) from the front of the computer. 2 Press the front panel into the computer. Pull each of the tabs out slightly, away from the computer, to release the panel.Ĩ Swing the front panel open toward the left, and then lift it off the computer. 7 Locate the three tabs that secure the front panel to the computer.
![change motherboard on hpe 510t change motherboard on hpe 510t](https://i.ebayimg.com/images/g/e84AAOSwV9JgviW7/s-l400.jpg)
5 Grasp the handle, and pull the side panel about 2.5 cm (1 inch) toward the back of the computer to release it. 6 Tilt out the top of the side panel, and then lift the panel from the computer. Tools Needed 2 Turn off the computer.Ĥ Loosen the side panel thumbscrew on the back of the computer. 3 Disconnect all peripherals and cables from the front and the back of the computer. 1 Remove the Pocket Media Drive, if it is present. Removing and Replacing the Front Panel 10–20 minutes Before You Begin Removing the Front Panel Observe the following requirements before removing and replacing the front panel.